During upload of Luminex files, we perform substitutions for certain flagged values. Other types of flagged values are imported without alteration.

Substitutions During Import for *[number] and OOR

We perform substitutions when Obs. Conc. is reported as OOR<, OOR> or *[number], where [number] is a numeric value. *[number] indicates that the measurement was barely out of range. OOR< and OOR> indicate that measurements were far out of range.

To determine the appropriate substitution, we first determine the lowest and highest "valid standards" for this analyte using the following steps:

1. Look at all potentially valid standards for this run. These are the initial data lines in the data table on the Excel page for this Analyte. These lines have either “S” or “ES” listings as their types instead of “X”. These are standards (Ss) instead of experimental results (Xs). Experimental results (Xs) are called Wells in the following table.
   
2. Determine validity guidelines. Valid standards have values in the (Obs/Exp) * 100 column that fall “within range.” The typical valid range is 70-130%, but can vary. The definition of “within range” is included at the end of each Excel page on a line that looks like: “Conc in Range = Unknown sample concentrations within range where standards recovery is 70-130%.”
3. Now identify the lowest and highest valid standards by checking the (Obs/Exp) * 100 column for each standard against the "within range" guideline.
   

N.B. The Conc in Range field will be *** for values flagged with * or OOR.

In the following table, the Well Dilution Factor and the Well FI refer to the Analyte Well (the particular experiment) where the Obs. Conc. was reported as OOR or as *[number].

Flagged Values Imported Without Change